2 # gebou, P5 zone Quan Shui, Ganjingzi distrik, Dalian, China

Alle kategorieë
EN
Bel Ons

+ 86-411-39641370

Stuur pos

vicente@konsond.com

maatskappy Nuus

home>Nuus>maatskappy Nuus

M1 Bright bar promotion

Tyd: 2023-07-07 Hits: 12

Aanwysing volgens Standaarde

Brand NaamMat. Geen.DINENAISI
KSD-M11.3346S2-9-1-M1

Chemiese samestelling (in gewig %)

CSiMnCrMoNiVWander
0.82Max. 0.45Max. 0.403.858.60-1.151.75-

Beskrywing
M1 is a molybdenum, chromium, vanadium alloy tool steel generally known as a Molybdenum High Speed Tool Steel. It is on of the most widely available tool steels in use today. It is similar in properties to the tungsten tool steels (T series) at a lower. Very tough high-speed Mo steel good grindability.

aansoeke
Twist drills, thread cutting tools, hobs and dies for broaching and cold flow pressing, cross recess dies for screw manufacture, cold rolling for e.g. Sendzimir equipment.
Fisiese eienskappe (gemiddelde waardes) by omgewingstemperatuur
Modulus of elasticity [103 x N/mm2]: 217
Digtheid [g/cm3]: 8.0
Termiese geleidingsvermoë [W/mK]: 19.0
Elektriese weerstand [Ohm mm2/m]: 0.60
Spesifieke hittekapasiteit[J/gK]: 0.46

Coefficient of Linear Thermal Expansion 10-6 oC-1

20-100oC20-200oC20-300oC20-400oC20-500oC20-600oC20-700oC
11.011.511.912.312.412.512.5

Sagte uitgloeiing
Heat to 820-850oC, cool slowly in furnace to 550oC then air. This will produce a maximum Brinell hardness of 262.

Stresverligting
Stress relieving to remove machining stresses should be carried out by heating to 600-650oC, holding for one hour at heat, followed by air cooling. This operation is performed to reduce distortion during heat treatment.

verharding
0 Harden from a temperature of 1180-1219oC followed by air or oil quenching or warm bath at 550oC. Hardness after quenching is 64-66 HRC.

temper
Tempering temperature: 530 – 560oC, at least 2x for at least 63 HRC.

bewerk
Hot forming temperature: 1100-900oC.

Koue werk
This alloy may be cold worked in the annealed condition.

bewerkbaar
M1 is classified as a “medium” machinable alloy. Machining should be accomplished prior to hardening heat treatment followed by finish grinding. It has a rating of 50% that of the water hardening (W group) low alloy tool steels in regard to machinability.

Weerstand teen korrosie
This is not a corrosion resistant alloy. In use as tooling it is often coated with oil to prevent rusting. A light film of oil. or protective wrapping, is essential to keep it free from corrosion.

Welding
Consult the alloy supplier for information on weld procedures.
Forms manufactured: Please see the Dimensional Sales Program.

2

3

4

5

6

8

Vorige: Geen

volgende: WAAROM KONSOND KIES?